 |
|
|
|
 |
|
||
 |
|
 |
|
 |
|
||
|
|
|
|
 |
|
||
 |
 |
 |
|
 |
|
||
|
The BMP-1 Board Marker Probe (patent pending) is designed for installation on loaded board test
fixtures. When your tester is equipped with the appropriate electronics and software, the BMP-1 scribes a permanent .050" circle on every good PCB tested. Boards that fail the test are not marked. The risk of human error is eliminated in PCB testing and sorting. The unit requires less than .500" of fixture area. It is designed to mark board areas of bare glass (FR4), solder mask over glass or copper, or bare tinned copper. The BMP-1 includes a mounting receptacle with press ring, and a motor/transmission assembly. It can be easily removed from the receptacle for use in other fixtures. Spare receptacles and tip replacement assemblies are available. The thread between receptacle and housing is 7/16-20 unf. Consult factory for information on electronic and software requirements, and replacement receptacles and tip assemblies. |
|
| Probe Specifications | BMP-1 |
| Mechanical | |
| Full Marker Tip Travel: | .062 (1.57) |
| Recommended Working Travel: | .050 (1.27) |
| Direction of Rotation: | CCW |
| Scribed Diameter: | .050 (1.27) |
| Special diameters available | |
|
Electrical (Operating Conditions) |
|
| Current Rating: | 50 mA |
| Voltage Rating: | 15VDC |
| Recommended Duty Cycle: | 1 sec. On (min.), 5 sec. Off |
|
Materials and Finishes |
|
| Plunger Tip: | Carbide |
| Receptacle: | Stainless steel |
| Mounting Hole Size: | .468/.469 (11.89/11.91) |
Board Marker Probe
How to Order (top)
Specify model number of components or tools you require:
BMP-1: Probe and receptacle, wires and connector attached, mating connector supplied, (-red, + black).
BMR-1: Receptacle only.
BMT-1: Tip replacement assembly for BMT-1.
RIT-BMP: Receptacle insertion tool for BMR-1.
EXT-BMP: Receptacle extraction tool for BMR-1.